A50 – M Super Heavy Cutting Compound

Feynlab A50 SUPER HEAVY CUTTING COMPOUND was engineered for the highest level of defect removal, on the hardest clear coats, while offering a high level of clarity. It’s Body shop safe and capable of removing 1000 grit sand scratches. Our rapid defect removal abrasives make quick work of even the heaviest defects or sanding marks. Formulated for both rotary and dual action polishers, this compound cuts fast with outstanding finishing capabilities, saving you time and money. Contains NO fillers, silicone, waxes or other conditioners.

PRODUCT BENEFITS

• Effortless removal of even the deepest surface imperfections, including 1000 grit sand marks
• Perfect for heavily scratched painted automotive finishes prior to FEYNLAB® coating
• Fast and consistent cut
• Cost saving as less product is needed when compared against the
• Simple & quick wipe off

APPROVED SURFACES FOR APPLICATION – DO NOT apply to unapproved surfaces

• Clear Coated Painted Surfaces
• Single stage paint surfaces
• Gel-coated surfaces

Cautions

We encourage to always wear gloves, an approved face mask and eye protection when using any compounds or polishes.

PREPPING THE SURFACE

• Place vehicle in a well-lit, cool, & contamination free environment
• Remove all excessive surface dirt and contaminants using either PURE WASH or PURE RINSELESS
• Clay the surface to remove any surface bonded contaminant

ROTARY POLISHER DIRECTIONS

• Shake the bottle vigorously for 1 minute before use. Regularly, give the bottle a few shakes during each compounding
• Prepare the wool pad by placing 4 dime size dots and spread around on the face of the pad. Then place 4 dime size dots on the face of the pad and spread around area to be
• In general, begin with a 2 x 2-foot section. Decrease working area if heavier correction is
• Using a speed of no more than 1600 rpm, make 2 – 4 slow passes over the given
• Wipe clear with a clean microfiber
• Check your results from multiple angles to ensure complete removal of
• Although A50 can be used as a final polish, Feynlab highly recommends a final polish with a DA Polisher to remove and rotary trails that may be left behind.
• Admire your Take lots of pictures. Brag about it to your friends and give the FEYNLAB® team a virtual high five.

DUAL-ACTION (DA) POLISHER DIRECTIONS

• Shake the bottle vigorously for 1 minute before use. Regularly, give the bottle a few shakes during each compounding
• Prepare the microfiber or foam pad by placing 4 dime size dots and spread around on the face of the pad. Then place 4 dime size dots on the face of the pad and spread around area to be
• In general, begin with a 2 x 2-foot section. Decrease working area if heavier correction is
• Using a speed of 3400 – 4000 opm, make 2 – 4 slow passes over the given
• Wipe clear with a clean microfiber
• Check your results from multiple angles to ensure complete removal of
• Admire your Take lots of pictures. Brag about it to your friends and give the FEYNLAB® team a virtual high five

SHELF LIFE
2 years in a normal, climate-controlled environment.